Made By Shock Dorctor. This is the top of the line mouthguard with a super tight compression Gel-Fit. The Gel Fit liner molds to the teeth for a tight but comfortable fit. The shock transfer core provides a new lightweight profile that fits closer and directs impact away from the vulnerable front teeth to the stronger triple-rooted molars to stabilize and shield the teeth. It has Air Cushion Shock Pads that have a new spring-effectjaw pads to ensure a more comfortable jaw compression rate and improved fit. The Mora Performance Enhancement ensures that when the mouthguard is fitted and worn correctly that it positions the lower jaw down and forward and the tongue up onto the roof of the mouth, which may increase strength and athletic performance. It has a convertible tether that has a quick-release and allows the mouthguard to be worn both strapped and strapless.

Mouthguard Fitting Instructions

Fill saucepan with 3 to 4 inches of water. Bring water to a boil.
Remove water from heat source. Immediately place mouthguard in water for 90 seconds. Do not remove before 90 seconds.
Carefully remove mouthguard from hot water with a slotted spoon.
Cool mouthguard under tap water for 1-2 seconds only to bring surface temperature to a comfortable level.
Lick your lips before placing mouthguard in your mouth.
Watching in mirror, line up mouthguard carefully with the centerline of upper teeth. Fit mouthguard onto and around upper teeth (tongue tag upward) and press firmly into molars first then front teeth.
Bring lower jaw forward and up into base of mouthguard with teeth in alignment with lower channel.
Close mouth while biting down hard on mouthguard. Suck in strongly and use fingers to press edges of mouthguard onto teeth and roof of mouth through lips and cheeks for 20 seconds.
Remove mouthguard and cool under tap water for 30 seconds. Replace into mouth and test for a good, firm fit.
Repeat steps 1 through 10 if fit is not accurate.